Tile and Tub Treatment
Does the sign "CAUTION WET FLOORS"
cause you worry every time it's displayed?
SafeSteps Products, LLC, has the solution
that will allow you to breathe more easily.
SafeSteps
is a slip resistant treatment
for ceramic and porcelain tile, stone,
concrete and fiberglass
.
 |
SafeSteps is safe, non-toxic & environmentally friendly. |
|
SafeSteps is a treatment that does not alter the appearance of either the tile or grout. |
|
SafeSteps has no harmful effects on substrates |
|
SafeSteps significantly improves slip resistance on wet floor surfaces that will typically meet or exceed safety recommendations from OSHA and The Americans with Disabilities Act. |
SafeSteps Tile and Tub Treatment is a mop on, rinse off solution that treats the surface of ceramic and porcelain tile, quarry, terrazzo, concrete, natural stone and fiberglass surfaces to help prevent slippery conditions particularly when wet.
SafeSteps Tile and Tub Treatment works at the micro-pore level to enhance the natural surface characteristics of these materials to increase traction and improve safety.
When properly applied and maintained, treated surfaces will typically have a slip coefficient exceeding ADA/OSHA slip-fall safety recommendations.
SafeSteps Tile and Tub Treatment is not used on vinyl, linoleum, wood, metal, coated, waxed or sealed surfaces. Care should be taken to protect carpets, molding and other adjacent materials.
Test Application Information
Use a floor Cleaner Degreaser or Shower Scrub to remove all soil, grease, oil, or shower scum.
Apply enough SafeSteps Treatment to thoroughly puddle and coat a section of the area being treated.
-
Treatment Solution should be used directly from the bottle without dilution.
-
Pour the solution directly onto the surface being tested and spread using a brush or mop. (Use a different applicator than the one used to clean the floor.)
-
After thoroughly wetting the worked area, agitate the liquid on the surface using the applicator to swill the liquid as it treats the surface.
-
Large areas should be treated in sections to allow for the material to work for 5-15 minutes directly on the surface without drying.
-
After 5-15 minutes, and before the treatment dries on the surface, remove the Treatment solution thoroughly from the floor surface. Thoroughly rinse the surface with clean clear water to completely remove the Treatment solution.
Porcelain and fiberglass application: On porcelain and fiberglass surfaces it may require a little more time for SafeSteps Treatment to work. Typical time to attain maximum slip-resistance has been determined to be between 7 and 10 minutes.
Slip resistance can be tested by sliding your feet across the area being treated to see how well it's working. |
